您现在的位置:主页 > 产品中心 > 压渣机组 >

型号:



国内首创中药废渣、挤压、卸料同步进行,挤出药液可过滤再用。
渣车卸料口小,通往底层下料通道只有1mx1m,楼板开洞小并可自
动开关门,防止药渣异味及蒸汽上升,对员工安全无后顾之忧。
使用触摸屏及PLC实现全自动控制,专用的滑线架和扁排线、架使用
寿命是其他形式的5倍以上。
渣已挤干,使运渣汽车再无到处滴液现象,保护厂内外卫生。
 

The first domestic waste residue of Chinese herbs, extrusion, discharging synchronously, extrusion physic liquor can be filtered for reuse.
Slag car unloading mouth small, leading to the bottom of the feeding channel is only 1mx1m, opening the floor small and self
Move to open closed, to prevent drug residue smell and steam rising, the safety of people worry about.
The use of the realization of full automatic control touch screen and PLC special slide wire frame and a flat cable, frame
Life is 5 times more than other forms of.
Slag have been squeezed, the slag transport vehicle is no longer dripping phenomenon everywhere, inside and outside health protection factory.





当提取罐有排渣要求时,遥控或触摸屏控制启动除渣车,运行到需要排渣的提取罐下方,打开提取罐排渣门,将中药废渣装载在除渣车的储渣斗内,遥控或触摸屏控制启动除渣车运行至大倾角输送机装载处,开启挤渣除渣车使药渣和药液同时分离,药液进入储液罐里(过滤可再用)或流入水处理中心,药渣同时进入大倾角输送机斗内,提至储渣仓里,而后装载在运输汽车上,运至厂外。
 
When extracting tank with a slag discharge requirements, remote control or touch screen control to start the slag car, run into the extracting tank below the need to slag, slag discharge door will open the extraction tank, the waste residue of Chinese herbs is loaded in the slag slag hopper car, remote control or touch screen control to start the slag car runs to the large inclination conveyor loader at the opening, slag slag car make dregs and liquid at the same time separation, liquid medicine into the liquid storage tank (filtration can be reused) or into the water treatment center, dregs and into the large inclination conveyor bucket, to Zhacang storage, and then loaded on the transport vehicles, transport to the factory.
 
储渣仓安装要求
1、预埋钢板承载量最大值根据设备型号选定。
2、整机与地面垂直度公差不大于3mm。         
3、预埋钢板间隔尺寸根据设备选定
 
1, embedded steel capacity maximum value according to the type of equipment selection.
2, the machine and the ground verticality tolerance is not more than 3mm.
3, pre embedded steel plate interval size according to the selection of equipment